Owner`s manual
80
Playback
1
Press Z2 or Z3 to set the remote
control unit to ZONE2 or
ZONE3 operation mode.
2
Press ON Z to turn on the ZONE2
or ZONE3 power.
•“ZONE2” or “ZONE3” appears on the
display.
•When STANDBY X is pressed, ZONE2 or
ZONE3 turns off.
•Power in ZONE2 can be turned on or off by
pressing ZONE2 ON/OFF or ZONE3 ON/OFF
on the main unit.
3
Press SOURCE d or SOURCE f.
The audio signal of the selected source is output to ZONE2 or
ZONE3.
•Every time you press
SOURCE d or SOURCE f, the input
source switches in the following order.
ZONE2/3 Source ZONE2/3 BD ZONE2/3 DVD ZONE2/3 VCR
ZONE2/3 SAT
ZONE2/3 TVZONE2/3 CD ZONE2/3 NET/USB
ZONE2/3 GAME
ZONE2/3 AUX2
ZONE2/3 AUX1
ZONE2/3 M-XPort
ZONE2/3 HD Radio
ZONE2/3 PHONO
z
z When “Source” is selected, the input source of ZONE2 or ZONE3
is the same input source as MAIN ZONE.
•Turn
INPUT SELECTOR after pressing ZONE SELECT on the main
unit to select an input source.
Adjusting the volume
Use VOLUME +, – to adjust the volume.
GAdjustable rangeH
– – –
–80dB – –40dB – 18dB
(When the “Volume Display” (vpage112) setting is “Relative”)
GAdjustable rangeH
0 – 41 – 99
(When the “Volume Display” (vpage112) setting is “Absolute”)
•At time of purchase, “Volume Limit” (vpage 111) is set to
“–10dB (71)”.
Turn VOLUME after pressing ZONE SELECT on the main unit to adjust
the sound volume.
Turning off the sound temporarily
Press MUTE.
The sound is reduced to the level set at “Mute Level” (vpage111)
in the menu.
•To cancel, either adjust the volume or press MUTE again.
•The setting is canceled when the zone’s power is turned off.
You can adjust the tone and volume for ZONE2 and ZONE3 in “Zone
Setup” (vpage111) in the menu.
Video output
Video Connection
The video signals of this unit’s ZONE2 video output terminal are
played by the ZONE2 TV.
VIDEO
IN
MAIN ZONE
ZONE2
This unit
NOTE
•It is not possible to output video signals input to the HDMI or
component terminals to ZONE2.
•The menu screen is not output.
Basic version
Advanced version
Information
Advanced version
vSee overleaf
BD