Operation Manual

z1
The applicable sound mode includes “Dolby Surround” and sound modes that have “+Dolby Surround” in the sound mode name.
z2
The applicable sound mode includes “DTS Neural:X” and sound modes that have “+Neural:X” in the sound mode name.
z3
A signal for each channel contained in an input signal is output as audio.
z4 Audio is output when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v
p. 240)
z5 Audio is not output when “Speaker Config.” - “Surr. Back” in the menu is set to “1 spkr”. (v p. 233)
z6
For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup in
place of Surround Height speakers.
z7
This is output if an Auro-3D signal is input and the input signal contains Top Surround.
z8
For the best Auro-3D experience Front Height and Surround Height speakers are recommended, however you may substitute Dolby Atmos Enabled speakers.
z9 Audio is output from the speakers specified in the “Surround Parameter” – “Speaker Select” settings. (v
p. 185)
Contents Connections Playback Settings Tips Appendix
309
Front panel Display Rear panel Remote Index