ST6001N DFU cover 06.1.
ST6001N DFU cover 06.1.20 10:33 AM ページ1 ENGLISH WARRANTY For warranty information, contact your local Marantz distributor. RETAIN YOUR PURCHASE RECEIPT Your purchase receipt is your permanent record of a valuable purchase. It should be kept in a safe place to be referred to as necessary for insurance purposes or when corresponding with Marantz. IMPORTANT When seeking warranty service, it is the responsibility of the consumer to establish proof and date of purchase.
ST6001N DFU cover 06.1.20 10:33 AM ページ2 CE MARKING English The ST6001 is in conformity with the EMC directive and low-voltage directive. Français Le ST6001 est conforme à la directive EMC et à la directive sur les basses tensions. Deutsch Das Modell ST6001 entspricht den EMC-Richtlinien und den Richtlinien für Niederspannungsgeräte. Nederlands De ST6001 voldoet aan de EMC eisen en de vereisten voor laag-voltage. Español El ST6001 está de acuerdo con las normas EMC y las relacionadas con baja tensión.
ST6001N DFU cover 06.1.20 10:33 AM ページ3 Español ADVERTENCIAS - No exponga el equipo a la lluvia ni a la humedad. - No extraiga la tapa del equipo. - No introduzca nada en el interior del equipo a través de los orificios de ventilación. - No maneje el cable de alimentación con las manos mojadas. - No cubra la ventilación con objetos como manteles, periódicos, cortinas, etc. - No deben colocarse sobre el equipo elementos con fuego, por ejemplo velas encendidas.
ST6001N 01 Eng 06.1.20 10:34 AM ページ1 ENGLISH CONTENTS FEATURES .............................................................................................................................................1 BEFORE USE .........................................................................................................................................2 PARTS NAMES AND FUNCTIONS........................................................................................................3 FRONT PANEL ...........
ST6001N 01 Eng 06.1.20 10:34 AM ページ2 ENGLISH BEFORE USE This section must be read before any connection is made to the mains supply. 7 EQUIPMENT MAINS WORKING SETTING Your Marantz product has been prepared to comply with the household power and safety requirements that exist in your area. ST6001 can be powered by 230V AC only. 7 COPYRIGHT Recording and playback of any material may require consent.
ST6001N 01 Eng 06.1.20 10:34 AM ページ3 ENGLISH PARTS NAMES AND FUNCTIONS FRONT PANEL !9 !2 !8 @0 !3 !4 FM/AM TUNER ST6001 DOWN ON/OFF TIMER DAILY TUNED STEREO RDS PTY TP TA PRESET UP TIMER SET MEMO PRESET CH kHz MHz STANDBY A POWER ON/STAMDBY q B ANTETTA w WIDE FM e NARROW IF BAND r TIME ADJ. ST.NAME /DISPLAY TUNING MODE DOWN tyu q POWER ON /STANDBY button This button is used to power on or power standby.
ST6001N 01 Eng 06.1.20 10:34 AM ページ4 ENGLISH PARTS NAMES AND FUNCTIONS FL-DISPLAY a b TIMER DAILY c d TUNED STEREO e RDS PTY f TP TA MEMO PRESET CH kHz MHz h a TIMER This indicator lights up when the daily timer is activated. b DAILY timer indicator This indicator lights up when the daily timer is engaged by pressing the TIMER SET button. c TUNED indicator This indicator lights up when a station is properly tuned in.
ST6001N 01 Eng 06.1.20 10:34 AM ページ5 ENGLISH PARTS NAMES AND FUNCTIONS REAR PANEL FM ANTENNA B FM ANTENNA A 75Ω 75Ω ∼ AM ANTENNA GND AM LINE OUT REMOTE CONTROL RESET L R q w e r q FM antenna terminals A/B (75 ohms) Connect an external FM antenna with a coaxial cable, or a cable network FM source. w AM antenna and ground terminals Connect the supplied AM loop antenna. Use the terminals marked “AM” and “GND”. The supplied AM loop antenna will provide good AM reception in most areas.
ST6001N 01 Eng 06.1.20 10:34 AM ページ6 ENGLISH CONNECTIONS Note Connect the tuner to other equipment in the below sequence to use the tuner. 1. Connect an FM antenna to the FM ANTENNA A terminal. 2. Connect an AM loop antenna to the AM ANTENNA terminals. The terminals do not have a particular polarity. 3. Connect the LINE OUT and REMOTE CONTROL connectors to their corresponding terminals on a stereo amplifier using the provided cords. (Turn power to the stereo amplifier OFF before making the connections.
ST6001N 01 Eng 06.1.20 10:34 AM ページ7 MEMORY PRESETTING 7 Manual operation For example: presetting FM 90.1 MHz, to Preset number. 10 1. Select the FM by using the BAND button !7. 2. Tune to 90.1 MHz by using the TUNING 5∞ button i. 3. Press the MEMO button !1 briefly (for less than 0.5 second) Then, “MEMO” will blink in the display. 4. Select the preset number by using the PRESET 5∞ button !4. 5. MEMO button !1 pushed again, 90.1 MHz (broadcast station) was able to be memorized in number 10 by this.
ST6001N 01 Eng 06.1.20 10:34 AM ページ8 ENGLISH OPERATIONS ADJUSTING CURRENT TIME 1. Press the TIME ADJ button t. Then “Hour display” 4. Preset the OFF time by the TUNING 5∞ button i and the NEXT button !0. (Same as operation of time adjust) indicator will blink. DAILY blink 2. The hour is set with the TUNING 5∞ button i. 5. Press the NEXT button !0. The timer setting is completed. TIMER DAILY TUNED STEREO MHz 3. Press the NEXT button !0. Then “minute display” indicator will blink.
ST6001N 01 Eng 06.1.23 10:27 AM ページ9 FILING (STATION NAME, ETC. ) RDS (RADIO DATA SYSTEM) For example: FM 98.8 MHz Preset CH-10 Station name BBC1 1. Select the preset number 10 in the preset mode. 1. What is RDS? RDS provides such indication as station names, local times, and the types of program, the radio text ,etc. as well as FM broadcasting. 2. You can receive the following kinds of data with this PRESET CH RDS. MHz 2. Press the ST.NAME/DISPLAY button y long pushed (for more than 1.
ST6001N 01 Eng 06.1.20 10:34 AM ページ10 ENGLISH OPERATIONS RDS DISPLAY 1. Select the FM band. RDS can be received only in FM. 2. Select the RDS broadcasting by using the TUNING 5∞ button i. Then, RDS will light up in the upper side of the FTD display. And the related data, if received, will be displayed in the type of received data (PTY, RT, TP, TA) 3. RDS 1) The default of the RDS mode is PS. 2) Press the RDS button !6. Each time you press the button briefly (1.
TROUBLESHOOTING If your Tuner should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or our service organization. Symptom Cause No sound Only noise is heard Measures • INPUT SELECTOR of amplifier is not Select “TUNER” in INPUT SELECTOR. • Volume of amplifier positioned in “MIN.” • The terminal for system connection is pullet out. • Set to “TUNER”. – • Adjust Volume accordingly. – • Connection correctly.
ST6001N 01 Eng 06.1.20 10:34 AM ページ12 LW Section frequency range ............146 kHz to 290 kHz (1 kHz step) Sensitivity (S/N: 20 dB) ..................................57 dBµV /m Signal to Noise ratio.................................................45 dB Total harmonic distortion..........................................1.0 % Image Rejection.......................................................35 dB FM section Frequency range .........................87.5 MHz to 108.
ST6001N DFU cover 06.1.20 10:33 AM ページ4 www.marantz.com You can find your nearest authorized distributor or dealer on our website. EUROPE Marantz Europe B.V. P.O. Box 8744, 5605 LS Eindhoven, The Netherlands is a registered trademark.
