User Guide Home Theater System ES7001

7
ENGLISH
NAMES AND FUNCTIONS OF PARTS
z
c
v
n
b
m
,.
⁄3
⁄0
⁄2
⁄1
x
REMOTE CONTROLLER:
RC002ES
7 Buttons used for this unit
z POWER button
Press this button to turn on the unit or to
set it to standby mode.
x Input select buttons
These buttons are used to select the input
source to be played.
Press the input source button you want
to play.
c Dolby PL II button
Press this button to switch the Dolby
Pro Logic
II sound field environment.
Each press switches among Pro Logic
II
MOVIE, Pro Logic
II MUSIC and OFF.
Note:
This button functions when the analog
input signal or 2-ch PCM input signal is
selected.
v NIGHT MODE button
Press this button when you want to lower
the volume of the source for cases such as
movie viewing at night.
As the enhanced parts of the reproduced
sound are suppressed in this mode, you
can enjoy the sound without elevating the
entire volume.
b MODE button
Press this button to listen to the binaural
recording source.
n BILINGUAL button
Press this button to switch the bilingual
sound output from the TV when the unit
receives a high-definition TV broadcast
(AAC audio signal).
m MAIN VOLUME + button
Press this button to increase the volume
of the unit.
, MAIN VOLUME – button
Press this button to decrease the volume
of the unit.
. MUTE button
Press this button to mute the sound
temporarily. Press it again to restore the
sound.
⁄0 DIMMER button
Press this button to dim the display
window.
⁄1 SUBWOOFER button
This button is used to activate a
commercially available or the Marantz
SW7001 subwoofer with a built-in amplifier
connected to the unit.
Note:
This function is activated at the factory.
When no subwoofer is connected to
the unit, press this button to turn off the
indicator.
⁄2 ELEVATION button
Press this button to switch the height of
the unit installation position. “L” (lower than
the TV position) or “H” (higher than the TV
position) can be selected.
⁄3 SEAT button
[For number of audience]
Press this button once to switch the number
of the audience between “1P” (one person)
and “2P” (two or more persons).
[For the viewing/listening distance]
Hold down this button for over 2 seconds to
switch the distance between the audience
and the unit from among “2 m or shorter,”
“Approx. 2 m” and “2 m or longer.”
Notes:
• When the audience is 2.5 m (98 1⁄2
inches) or farther away from the unit
and the viewing/listening distance is
set to “2 m or longer,” the stereophonic
effect of the unit may be reduced.
• When the audience is close 1.5 m
(59 1/8 inches) or less to the unit and
the viewing distance is set to “2 m or
shorter,” the stereophonic effect of the
unit may be reduced.
ES7001_U_01_Eng.indd 7ES7001_U_01_Eng.indd 7 07.7.31 1:42:33 PM07.7.31 1:42:33 PM