Owner`s manual

44
Audio Settings
Settings for audio output are made.
Audio Output
Default settings are underlined.
Set the audio output.
Setting items Setting details
Coaxial
Selects the audio format
output from the digital audio
out connector.
Bitstream : For selecting when the device connected to the unit supports
Dolby Digital or DTS Digital Surround.
PCM : For selecting when a device connected to the unit does not support
Dolby Digital or DTS Digital Surround.
Off : For outputting no audio signals from the digital audio out connector
of the unit.
For converting audio signals, see “About digital signal audio output”
(vpage59).
HDMI
Sets the audio format output
from the HDMI output
connector.
Bitstream : For selecting when the device connected to the unit supports
Dolby TrueHD/Dolby Digital Plus/Dolby Digital or DTS-HD/DTS Digital
Surround. The output format is automatically selected according to the
audio format or the number of channels supported by the connected
HDMI device.
PCM : For selecting when a device connected to the unit does not support
Dolby TrueHD/Dolby Digital Plus/Dolby Digital or DTS-HD/DTS Digital
Surround.
Off : For outputting no audio signal from the HDMI output terminal of the
unit.
For converting audio signals, see “About digital signal audio output”
(vpage59).
NOTE
If “BD Audio mode” is set to “HD Audio Output”
with OPTION on the remote control, BD secondary
audio and interactive audio are not output.
Down Sampling
Selects the sampling rate
output from the digital audio
out connector.
48kHz/96kHz/192kHz
NOTE
•The audio signal of content protected by copyright protection is
downsampled to a 48kHz, 16 bit signal.
•If the device connected to the unit does not support a 96kHz/192kHz
sampling rate, a lot of noise will be generated from the connected device
if this unit is set to 96kHz/192kHz.
Dynamic Range
Compression
Compresses the dynamic
range of Dolby TrueHD/
Dolby Digital Plus/Dolby
Digital Audio.
Off : Dynamic range is not compressed.
On : Dynamic range is compressed.
Auto : Dynamic range of Dolby TrueHD audio is automatically compressed
according to the material. Audio of Dolby TrueHD only is compressed.
This setting compensates high volume to low and low volume to high
when high volume is not desired at night.
Setting items Setting details
BALANCED Polarity
Sets the output polarity
from the BALANCED OUT
connectors.
Normal：Normal polarity.
Reverse：Reversed polarity.
The initial setting of the pin arrangement for the BALANCED OUT
connectors on this unit is as follows.
① GND ② HOT(+) ③ COLD(-)
Basic version
Advanced version
Information
Advanced version
DVD