Server Installation and Configuration Guide

Marathon Technologies Corporation 25
On the Endurance Network Setup page make sure that the desired
adapter is still highlighted and select Use currently configured IP
addressing. Click Next to continue.
3. If your network configuration will not use CoServer Link 2, select No
Coserver Link 2 and then click Next without selecting an adapter.
If you will be using CoServer Link 2, then on the Configure CoServer
Link2 page, highlight the adapter you wish to assign as CoServer Link2
in the Connection column. Select the adapter based upon the PCI loca
-
tion-to-switchbay mapping you established during planning and prepara-
tion. You can use Table 1 to assign IP addresses for internal CLink
connections.
Right click on the adapter selection and choose Internet Protocol Prop-
erties from the action menu. On the Internet Protocol Properties page
select Use the following IP address and fill-in the appropriate address.
Then, enter Subnet mask 255.255.255.0 and click OK.
On the Endurance Network Setup page make sure that the desired
adapter is still highlighted and select Use currently configured IP
addressing. Click Next to continue.