Installation guide

14 15

Step 5: Remove the three screws holding the top control enclosure onto the

motor. Carefully lift the top panel and turn it over to expose the inside

of the terminal box.

Step 6: RuntheHighSpeedBlack,LowSpeedRed,L2,andGroundwiresfrom

the conduit cable through the opening on the right side of the motor.

Step 7: Connect the wire for Circuit 1 from the timer to the opening directly

acrossfromtheBLACKwireontheterminalblock(refertoFigure10).

Step 8: Connect the wire for the Circuit 2 from the timer to the opening directly

acrossfromtheREDwireontheterminalblock(refertoFigure10).

Step 9: Connect the L2 to the opening directly across from the WHITE wire on

theterminalblock(refertoFigure10).

Step 10: Connect the ground to the opening directly across from the GREEN/

YELLOWwireontheterminalblock(refertoFigure10).

Step 11: Screw in the conduit connector into the terminal box on the right side

of the terminal box.

Step 12: Carefully fold the extra wires inside the terminal box and place the top

control panel back on top of the terminal box.

Step 13: Tighten the three screws into the terminal box while applying light

pressure to the top control enclosure.

Step 14: Replace and tighten the screws to mount the seal plate onto the motor.

Step 15: Put a NEW pump seal into the seal plate and onto the motor shaft.

Handle and lubricate seal per manufacturer’s specications.

Figure 10