Installation guide

16 17
16 17
Step 9: Plugtheconnectorendofthelowvoltagecable(P/N391-200-01or
P/N391-200-02)intotheconnectorontheundersideofthetopcontrol
enclosureasseeninFigure13.
Step 10: Carefully fold the extra wires inside the terminal box and place the top
control panel back on top of the terminal box and tighten the three
topside enclosure screws.
Step 11: Carefully pull the low voltage cable to reduce the amount of excess
cable inside the connection box. Tighten the connector nut.
Step 12: The connection of the low voltage
wires at the automation controller
should be to the HOT side of the
auxiliary/AUXrelays(redandblack
wire on the top side of the relay).
Depending on the manufacturer of
the automation controller, you may
need to remove the cover plate on
these relays to gain access to the
terminals.
Note: The pictures shown in this section are
provided for illustrative purposes only.
The actual conguration of the auto-
mation controller at installation site
may be dierent than what is shown.
Refer to the controller operations
manual for proper identication of
AUXrelays.
Figure 13 Figure 14
Figure 15
Figure 16