Installation guide

18 19

Notes:

1. The automation controller allows for the programmable operation of

all three speeds. The motor will start on high speed for each speed

selection and operate through its two-minute prime cycle before

reacting to any controller inputs. The on time and speeds should be set

so that the pool can meet the total number of turns as required by local/

state regulations.

2. The user can override the operational speed currently being set by the

automation controller via the buttons on the top control panel. The

override will continue until either the power is removed by the

automation controller or a new speed is requested by the automation

controller. Other than the initial start-up prime cycle, a change in speed

can be initiated at any time via the top side control panel buttons.