Installation guide
8 9
8 9
Topside Interface Overview
The topside interface on the imPower motor provides functionality to change
amongst three distinct preset speeds via either a button press or by a remote
timer / automation controller. Green display LED’s will light to indicate the
currently selected speed as well as to indicate power is applied to the motor. A
red Error LED is also included to show a fault identied by the on-board diagnostic
system.
The following are the LED lights that will shine in each normal operational
condition.
This condition is present:
1. Directly after energizing the motor
2. After selecting high speed via a button
press
3. After selecting high speed via a timer or
automation controller
This condition is present
1. After selecting medium speed via a but-
ton press
2. After selecting medium speed via an
automation controller
3. After two hours of high speed operation
if the factory default automatic speed
selection was changed to medium (refer
to page 20)
This condition is present
1. After selecting low speed via a button
press
2. After selecting low speed via an automa-
tion controller
3. After two hours of high speed operation
if the factory default automatic speed
selection was changed to medium (refer
to page 20)
Notes:
1. The red Error LED will blink once after power is applied to the motor. This
indicates the internal self-check has returned normal results.
Figure 1
Figure 2
Figure 3