User`s guide
Table Of Contents
- Introduction
- Magnum Router Features
- Pre-Installation
- Installing the Hardware
- Magnum Router Manager Installation
- Logging Onto a Magnum Router
- Magnum Router GUI Manager
- Magnum Router Manager Main Screen
- Toolbar Buttons
- New Config Button
- Port Config Button
- WAN Config Button
- Other WAN Config Buttons
- Master WAN-IP Address
- WAN-IP Route Map
- Advanced Routing
- RIP Version 1 Routing
- Ethernet Config Button
- Micro-Band Voice Over IP
- Save Configuration
- Send Configuration
- Reboot the Magnum Router
- Menu Bar
- Configuration Menu (ALT-C)
- Settings Menu (ALT-S)
- System Menu (ALT-Y)
- Statistics Menu (ALT-T)
- Help Menu Item (ALT-H)
- Exit Menu Item (ALT-X)
- Toolbar Buttons
- Magnum Router Manager Main Screen
- Magnum Router Specialized Functions
- Sample Configurations
- Magnum Router Troubleshooting
- Magnum Router Cable Specifications
- Marathon Port Configuration
- Configuration Worksheets
Chapter 9: Sample Configurations
___________________________________________________________________
9-41
The only additional information needed is to program the route for the remote network into
Magnum B’s WAN IP Route Map table as shown below:
On Magnum A, RIP routing needs to be enabled. To do this, click on the WAN Config button,
then select the WAN IP Route Map button and finally the Advanced Routing button. The
following screen will be displayed:
In the upper right hand corner of this screen is a box to enable or disable RIP Version 1 routing.
Click on the box to add or remove the check mark signifying that RIP is enabled or disabled and
then click on Sav
e followed by Exit.