User`s guide
Table Of Contents
- Introduction
- Magnum Router Features
- Pre-Installation
- Installing the Hardware
- Magnum Router Manager Installation
- Logging Onto a Magnum Router
- Magnum Router GUI Manager
- Magnum Router Manager Main Screen
- Toolbar Buttons
- New Config Button
- Port Config Button
- WAN Config Button
- Other WAN Config Buttons
- Master WAN-IP Address
- WAN-IP Route Map
- Advanced Routing
- RIP Version 1 Routing
- Ethernet Config Button
- Micro-Band Voice Over IP
- Save Configuration
- Send Configuration
- Reboot the Magnum Router
- Menu Bar
- Configuration Menu (ALT-C)
- Settings Menu (ALT-S)
- System Menu (ALT-Y)
- Statistics Menu (ALT-T)
- Help Menu Item (ALT-H)
- Exit Menu Item (ALT-X)
- Toolbar Buttons
- Magnum Router Manager Main Screen
- Magnum Router Specialized Functions
- Sample Configurations
- Magnum Router Troubleshooting
- Magnum Router Cable Specifications
- Marathon Port Configuration
- Configuration Worksheets
Chapter 5: Magnum Router Manager Installation
___________________________________________________________________
5-1
he Magnum Router GUI Manager is installed much the same as any Windows software.
ollow these easy steps:
xit all open Windows programs.
sert the Magnum Router GUI Manager cd in your computers cd drive.
puter and select
rive x: (where x is the CD-ROM drive) and double-click on the Setup program.
nce the Setup program is started, the pre-installation screen will be displayed as shown below:
Chapter 5: Magnum Router Manager Installation
About the Manager Software
The Magnum Router GUI Manager is a configuration and management software for the
Magnum Router that runs on Windows. The Manager functions much the same as other
Windows programs.
The following will be required to install the software:
• The Magnum Router GUI Manager installation disk.
• PC with a hard drive that has at least 2 Mb of available space and a CD-ROM drive
• Windows 95, 98, 2000, ME, XP or NT workstation 4.0 PC operating system
Installing Manager Software
T
F
E
In
The Setup program should automatically start. If it does not, click on My Com
d
O
Figure 1 - Setup Pre-Installation Screen
In some cases, the Setup program needs to do a pre-installation of certain support
programs, and then requires a reboot for these programs to take effect. If this occurs, after the
reboot, just restart the Setup program as outlined below.
If this is an upgrade from a previously installed version of the Magnum Router Manager,
follow the “Upgrading” steps below.