User`s guide
Table Of Contents
- Introduction
- Magnum Router Features
- Pre-Installation
- Installing the Hardware
- Magnum Router Manager Installation
- Logging Onto a Magnum Router
- Magnum Router GUI Manager
- Magnum Router Manager Main Screen
- Toolbar Buttons
- New Config Button
- Port Config Button
- WAN Config Button
- Other WAN Config Buttons
- Master WAN-IP Address
- WAN-IP Route Map
- Advanced Routing
- RIP Version 1 Routing
- Ethernet Config Button
- Micro-Band Voice Over IP
- Save Configuration
- Send Configuration
- Reboot the Magnum Router
- Menu Bar
- Configuration Menu (ALT-C)
- Settings Menu (ALT-S)
- System Menu (ALT-Y)
- Statistics Menu (ALT-T)
- Help Menu Item (ALT-H)
- Exit Menu Item (ALT-X)
- Toolbar Buttons
- Magnum Router Manager Main Screen
- Magnum Router Specialized Functions
- Sample Configurations
- Magnum Router Troubleshooting
- Magnum Router Cable Specifications
- Marathon Port Configuration
- Configuration Worksheets
Chapter 5: Magnum Router Manager Installation
___________________________________________________________________
5-3
Click on the Setup button at the top of the screen to continue the installation.
Figure 4 - Setup Program, Program Group
During the installation, the setup program will request a program group. By default, the program
group is Magnum Router Manager. Enter another Program Group name, select one from the
list, or click on C
ontinue to proceed.
After clicking the Continue button, the setup program will install the Magnum Router Manager
files into the disk/directory selected earlier.
Depending on what software that may be installed on the PC, a Version Conflict message may
appear as shown below
Figure 5 - Setup Program, Version Conflict Screen
If this message appears, it is advised that the newer file is always kept. In the above example,
Y
es was selected to keep the existing file.