User`s guide
Table Of Contents
- Introduction
- Magnum Router Features
- Pre-Installation
- Installing the Hardware
- Magnum Router Manager Installation
- Logging Onto a Magnum Router
- Magnum Router GUI Manager
- Magnum Router Manager Main Screen
- Toolbar Buttons
- New Config Button
- Port Config Button
- WAN Config Button
- Other WAN Config Buttons
- Master WAN-IP Address
- WAN-IP Route Map
- Advanced Routing
- RIP Version 1 Routing
- Ethernet Config Button
- Micro-Band Voice Over IP
- Save Configuration
- Send Configuration
- Reboot the Magnum Router
- Menu Bar
- Configuration Menu (ALT-C)
- Settings Menu (ALT-S)
- System Menu (ALT-Y)
- Statistics Menu (ALT-T)
- Help Menu Item (ALT-H)
- Exit Menu Item (ALT-X)
- Toolbar Buttons
- Magnum Router Manager Main Screen
- Magnum Router Specialized Functions
- Sample Configurations
- Magnum Router Troubleshooting
- Magnum Router Cable Specifications
- Marathon Port Configuration
- Configuration Worksheets
Chapter 6: Logging Onto a Magnum Router
___________________________________________________________________
6-5
Console Login
The default for logging onto a Magnum Router is a serial connection from the PC that is running
the Magnum Router Manager software to a Magnum Router card. The connection is
accomplished by connecting either the supplied DB-9 to DB-25 straight thru cable (or
equivalent) from the PC to the Magnum.
The settings for serial communication with a Magnum Router is 9600 Baud, 8 bits, No Parity
and 1 stop bit (commonly referred to as 9600,n,8,1) and cannot be changed.
As can be seen in the above screen, Console is already selected as the Login Method. Click
on the C
onnect button to begin the login process.