User`s guide
Table Of Contents
- Introduction
- Magnum Router Features
- Pre-Installation
- Installing the Hardware
- Magnum Router Manager Installation
- Logging Onto a Magnum Router
- Magnum Router GUI Manager
- Magnum Router Manager Main Screen
- Toolbar Buttons
- New Config Button
- Port Config Button
- WAN Config Button
- Other WAN Config Buttons
- Master WAN-IP Address
- WAN-IP Route Map
- Advanced Routing
- RIP Version 1 Routing
- Ethernet Config Button
- Micro-Band Voice Over IP
- Save Configuration
- Send Configuration
- Reboot the Magnum Router
- Menu Bar
- Configuration Menu (ALT-C)
- Settings Menu (ALT-S)
- System Menu (ALT-Y)
- Statistics Menu (ALT-T)
- Help Menu Item (ALT-H)
- Exit Menu Item (ALT-X)
- Toolbar Buttons
- Magnum Router Manager Main Screen
- Magnum Router Specialized Functions
- Sample Configurations
- Magnum Router Troubleshooting
- Magnum Router Cable Specifications
- Marathon Port Configuration
- Configuration Worksheets
Chapter 6: Logging Onto a Magnum Router
___________________________________________________________________
6-9
Modem
By default, the Magnum Router manager does not send any command strings to the attached
modem. In some cases, it is necessary to send special commands to the PC’s modem in order
to make it work properly. The Magnum Router Manager has the ability to send up to 5 of these
special commands.
Special modem commands can be accessed from the Modem Parameters button of the
Communications Settings screen. The communications settings screen is located in the
Settings menu, Communications Settings menu item.
The following screen will then be displayed.
Select Modem Params or press ALT-M and the following screen will be displayed:
Enter the commands required and click on Sav
e to save these settings, and then click on Exit
to return to the Communications Settings screen.