User`s guide
Table Of Contents
- Introduction
- Magnum Router Features
- Pre-Installation
- Installing the Hardware
- Magnum Router Manager Installation
- Logging Onto a Magnum Router
- Magnum Router GUI Manager
- Magnum Router Manager Main Screen
- Toolbar Buttons
- New Config Button
- Port Config Button
- WAN Config Button
- Other WAN Config Buttons
- Master WAN-IP Address
- WAN-IP Route Map
- Advanced Routing
- RIP Version 1 Routing
- Ethernet Config Button
- Micro-Band Voice Over IP
- Save Configuration
- Send Configuration
- Reboot the Magnum Router
- Menu Bar
- Configuration Menu (ALT-C)
- Settings Menu (ALT-S)
- System Menu (ALT-Y)
- Statistics Menu (ALT-T)
- Help Menu Item (ALT-H)
- Exit Menu Item (ALT-X)
- Toolbar Buttons
- Magnum Router Manager Main Screen
- Magnum Router Specialized Functions
- Sample Configurations
- Magnum Router Troubleshooting
- Magnum Router Cable Specifications
- Marathon Port Configuration
- Configuration Worksheets
Chapter 7: Magnum Router GUI Manager
___________________________________________________________________
7-45
List DLCI’s
The List DLCI’s command is used to report the DLCI’s that have been reported on each port.
This includes any that have been programmed, and any that have been learned from any other
source. This screen just reports the DLCI’s, it DOES NOT display detailed DLCI information,
use the Display Port Statistics command in the Statistics menu for detailed DLCI status
information.
Next to each listed DLCI is the state of the DLCI.
C means that the listed DLCI has been configured
R means that the listed DLCI has been reported
A means that the listed DLCI is active
This information is also supplied in the Display Detailed Port Information menu item of the
Statistics menu.