Installation Guide

Travisano Bernini Mosaic
tile shown in grid pattern
Installation of
MOSAIC GLASS
& STONE
INSTALLATION INSTRUCTIONS | GLASS & STONE MOSAIC | PAGE 1 OF 5
Tile may be
installed over most
structurally sound
substrates.
Make sure surface
is clean, smooth,
dry and free of
wax, soap scum
and grease.
Any damaged,
loose or uneven
areas must be
repaired, patched
and leveled.
Remove any
moldings, trim,
appliances or
anything that
could interfere
with installation.
Find the center point of the wall,
using a level to draw a plumb line
in the wall’s center.
Lay out a row of loose tiles across
the bottom of the wall from the
center line leaving uniform joints
between tiles.
NOTE: Tiles can be butted together
leaving a consistent 1/16 in. joint
automatically.
TIP: If cuts leave tiles smaller than
half to their original size, adjust
the center line a half tile closer to
the wall.
Stack two tiles here. At the top,
draw a horizontal line on the wall
and continue the line around all side
walls to be tiled.
STEP 1: SURFACE PREPARATION
1
STEP 2: WALL LAYOUT
2
CONTINUED ON NEXT PAGE

Summary of content (5 pages)