Specifications

Enter Setup

1560 Series Barcode Scanner User Guide

1.6.6 ALTERNATE MODE

The scanner will start scanning once the trigger is pressed

 The scanning won't stop until you press the trigger again.

Alternate Mode

1.6.7 AIMING MODE

The scanner will aim at a barcode once the trigger is pressed, and start scanning when

the trigger is pressed again within one second.

 The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout

expires.

Aiming Mode

Aiming Timeout

You can limit the aiming time interval (1~15). By default, the scanner time-out is set to 1 second.

Aiming Time-out

fter 1~15 sec.

(*1)

1. Read the barcode above to specify the time interval before aiming ends. (It is set to 1 by

default.)

2. Read the “Decimal Value” barcode on page 227. For example, read “1” and “0” for the scanner

to automatically shut down after idleness for 10 seconds.

3. Read the “Validate” barcode on the same page to complete this setting.