Service manual
Service Manual 1000615 Filtro Jug MF 1000616 Filtro Flask MF 02-05-06 Page 3 of 9
TECHNICAL DETAILS
Model
Manual-Fill Jug
1000615
Manual-Fill Flask
1000616
Supply voltage
230V
230V
Frequency
50Hz
50Hz
Power
2300W
2100W
Dimensions
220x385x460 [WxDxH]
mm
220x385x615 [WxDxH]
mm
Empty Weight
6.1kg
7.1kg
Capacity (per hr)
18L
18L
Brew time
5 min
6.5 min
Brew capacity max
1.8L
2.2L
INSTALLATION
ELECTRICAL
Electrical specification: 230Vac. 50Hz.
This machine must be connected to a fused 13A single-phase power supply.
This machine is provided with a 3-pin plug and must be connected to an earthed supply.
LOCATION
Position the brewer at buffet height on a firm level base that can bear the weight of the machine
when it is filled.
Position the brewer level and in such a way that it cannot cause any damage if it leaks.
Position the brewer within 1.5 metres from a suitable power socket.
OPERATION
Allow time for all the coffee to drain from the filter bowl before removing.
Protect the controls against grease and dirt.
Never use warm or hot water to fill the machine.
Risk of scalding. Beware of removing the filter basket/jug/flask when the brewer is in operation.
ALL users of this machine should be trained and should be aware that the machine dispenses very
hot beverages.
Do not place an empty glass jug on a hotplate when it is switched on except immediately before
brewing.
PRIMING
The coffee machine needs to be primed with water prior to being turned on and its first operation; an amount
of water will always remain in the machine.
Insert an empty filter basket into the machine and place an empty jug/flask on the lower hotplate (or
base in the case of the flask version)
Pour a jug (1.8l/2.2l) of water into the tank (cold water reservoir).
Plug the machine into the power supply and switch on the power button. The switch indicator and
‘Brewing’ light will illuminate and the buzzer will sound for 1sec. The boiler will heat up and water
will start to flow through the machine.
At the end of the process the ‘Brew Ready’ light will illuminate and the buzzer will sound. Only half of
the water will have transferred to the jug/flask and the remainder will stay in the machine.