User`s manual

DSM150 User’s Manual
Page 172 Revision 1.4.16a
Figure 193 – Configuring the Operating Mode
6.23.8 Gauge Resistance, + to Sender
If the desired operating mode is “NMEA 2000 & Analog Gauge”, the two gauge resistances must be
programmed (please refer to the TLA100 User’s Manual for details on how to perform these
measurements). A screenshot of the + to sender gauge resistance configuration is shown in Figure
194 below. To program the + to sender gauge resistance, use the Scroll Up ( ) or Scroll Down (
) keys to move the highlighted cursor over the “Gauge Resistance, + to Sender:” menu item.
Then, press the Enter key ( ) to move the highlight over the numerical resistance value. Use the
“Increase” and “Decrease” keys to change the value to the measured resistance value, and finally,
press the Enter key ( ) to confirm your selection and store the value within the TLA100.
Figure 194 – Configuring the + to Sender Gauge Resistance
6.23.9 Gauge Resistance, - to Sender
If the desired operating mode is “NMEA 2000 & Analog Gauge”, the two gauge resistances must be
programmed (please refer to the TLA100 User’s Manual for details on how to perform these
measurements). A screenshot of the - to sender gauge resistance configuration is shown in Figure
195 below.