User`s manual

Revision 1.4.16a Page 173
®®
To program the - to sender gauge resistance, use the Scroll Up ( ) or Scroll Down ( ) keys to
move the highlighted cursor over the “Gauge Resistance, - to Sender:” menu item. Then, press the
Enter key ( ) to move the highlight over the numerical resistance value. Use the “Increase” and
“Decrease” keys to change the value to the measured resistance value, and finally, press the Enter
key ( ) to confirm your selection and store the value within the TLA100.
Figure 195 – Configuring the - to Sender Gauge Resistance