User`s manual

DSM150 User’s Manual
Page 32 Revision 1.4.16a
“On”. The background will switch to black and the percentage color settings are now used to define
the foreground color.
5.2.4.5 Demo Mode
The DSM150 has a demo mode suited for display
ing the capabilities of the unit. It causes the
DSM150 to operate in a “simulated data” mode, where the DSM150 will install a set of pre-defined
favorite screens and other configuration and will then display only the internally generated simulated
data and will ignore any data arriving over the NMEA 2000
®
bus. While in demo mode, the DSM150
will display a “Demo” indicator in the upper right hand corner of the screen. Programming this option
to “On (Show Room Mode)” or “On (Boat Show Mode, No Auto Reset)” will cause the DSM150 to
enter the demo mode while programming this option for “Off (Normal Use Mode)” will cause the
DSM150 to return to using data from the NMEA 2000
®
bus.
In order to be able to demonstrate all of the DSM150’s capabilities, the unit allows the user to setup
and configure different screens while in demo mode. However, in a show room environment and five
minutes after the last button push (i.e., the customer has walked away the demo unit), the DSM150
will reset itself to the default screens. There are others times where it is important that the DSM150
doesn’t automatically reset after five minutes to the default screens, for example at a boat show
where it is desired to show specific screens while running in the demo mode and thus the “Boat Show
Mode”.
WARNING: All data displayed in demo mode is simulated. Do not use this data for vessel monitoring
or navigation purposes.
Figure 18 – Setting the Demo Mode
5.2.4.6 Keyboard Beep
The DSM150 has an annunciator that can be programmed to beep every time a key is pressed.
Conversely, the keypad beep may be disabled if desired.