User`s manual

Revision 1.4.16a Page 43
®®
Maretron Run Indicator Monitor (RIM100) – Set Data Instance for the device, and labels for the
device and each channel.
Maretron Switch Indicator Monitor (SIM100) – Set Data Instance for the device, and labels for
the device and each channel. Set each channel mode.
Maretron Solid Sate Compass (SSC200) – set installation offset, perform magnetic deviation
calibration, check magnetic deviation calibration status, invert installation, configure magnetic
variation settings, setup NMEA0183 interface, program rate of turn damping, zero the rate-of-
turn offset, and enable/disable individual NMEA 2000
®
PGN transmissions.
Maretron Tank Level Adapter (TLA100) – Set tank type and tank number, set operating mode,
set tank capacity, and calibrate for irregular shaped tanks.
Maretron Tank Level Monitor Shallow (TLM100) – Set tank type and tank number, set operating
mode, set tank capacity, and calibrate for irregular shaped tanks.
Maretron Tank Level Monitor Gasoline (TLM150) – Set tank type and tank number, set
operating mode, set tank capacity, and calibrate for irregular shaped tanks.
Maretron Tank Level Monitor Deep (TLM200) – Set tank type and tank number, set operating
mode, set tank capacity, and calibrate for irregular shaped tanks.
Maretron Temperature Monitor (TMP100) – Set device label and channel instance, temperature
source (type) and label.
Maretron NMEA 2000 to USB gateway (USB100) – allows configuration of USB100s on network
Maretron Vessel Data Recorder (VDR100) – Set device label
Maretron Ultrasonic Wind and Weather Station (WSO100) – set installation offset, set wind
damping rates, and enable/disable individual NMEA 2000
®
PGN transmissions.
More device types will be included in future firmware releases.
In each case, the contents of the Device Configuration menus may vary depending on the version of
the firmware within the device.
The “Device Configuration…” menu is shown in Figure 29.
Figure 29 – Device Configuration Screen
The “NA” column of the menu displays the node address the device is using.
The “Manufacturer” column of the menu displays the manufacturer of the device.
The “Model” column displays the model number of the device.