User Manual

Hold the back bracket hanger in position against the wall in the desired hanging location.

Check to make sure that the bracket is level. Mark the wall where the mounting holes should

be located. Drill holes of¼" diameter in the marked locations. If you are on a stud, screw the

bracket directly into the wal I. If you are not on a stud, insert the plastic anchor in the hole,

and secure the bracket using the screws supplied (Fig.10).

Remove (4) screws and washers (Fig 11) from the unit to free the front cover. Carefully lift the

front cover off the unit a few inches. Disengage the ribbon cable connecting the front cover

LCD panel to the main control board or the unit (Fig 12). Remove the cover completely.

Please note: If LCD connection cable cannot be disengaged, simply set the front cover aside

and keep the cable connected.

Fig. 10

Fig. 11