User Manual
Fig.12
Attach unit to mounting bracket by sliding onto tabs. Make sure the unit is properly secured
to both tabs of the bracket. Install bottom, center screw to afx the unit to the bracket to
complete mounting.
Important notes about water connections:
1. All water pipe must comply with national and applicable state and local water pipe codes.
2. The unit should be connected directly to the main water supply. Flush pipe with water to
remove any debris or loose particles.
3. AlI connections to the unit should be ¾" NPT. Larger pipe can be connected but the
appropriate adapters must be used.
4. Please remember to install rubber seal rings at the connections. When all water
connections are completed, check for leaks and take corrective action before proceeding.
Connect the cold water supply to the threaded pipe labeled "inlet" and the hot water to
the threaded pipe labeled "outlet." IMPORTANT: RUBBER WASHER MUST BE USED FOR
PROPER SEAL.
14