GA22ONG/LP JSW44-22ST58 GA26ONG/LP JSW52-26ST58 GA30ONG/LP JSW60-30ST58
ion
room Installation: Do not install water heater where flammable products will be stored or used unless the main burner flame is at least 18" above the floor. This will reduce but not eliminate the risk of vapors being ignited by the main burner flame.
-This water heater must only be used with the following water supply system conditions: -With clean, potable water free of corrosive chemicals, sand, dirt, or other contaminants. -With inlet water temperatures above 32℉(0℃), but not exceeding 118℉(48℃). -Do not reverse the hot and cold water connections. The water heater will not operate. ·Even when drained properly, a small amount of water will remain in the water heater. In cold weather conditions, this water can be frozen.
safety devices. Refer repairs to qualified service personnel.
Before operating this water heater, be sure to read and light. It is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand. area , do If the knob will or turn by hand, don`t try to repair it, call a qualified service technician. Force or STOP! Read the safety information above on this label. Turn off all electric power to the appliance. Do not attempt to light the burner by hand. Wait five(5) minutes to clear out any gas.
ect
Reffering to this chart -O
GA30ONG/LP
Specifications Outdoor 150,000Btu/hr Models (GA22ONG/LP) (GA26ONG/LP)
S
If it still does not operate with the hot water faucet
nce Failure to peform routine preventive maintenance ou with the water cut off and the electrical power supply disconnected. professional to professional when abnormal sounds are noted. f valve It is recommended that a periodic inspection of the unit be performed to ensure proper operation by turning on hot water faucet.
owing comparison with pictorial sketches or drawings. obstructing the flow of combustion and ventilation air. avoid hot water.
been drained from the water heater. Leave water heater as is until placed back in service.
fixtures.
Maintenance Code 1 Protection due to temp. sensor Open or short circuit of temp sensor at water inlet at water inlet There is flame signal feedback during pre-check before applance starts up. 10 11 Possible Cause Description Protection due to flame feedback signal 12 Fail to ignite The continous combustion goes off accidentally. Thermostat is not connected when appliance starts up. 13 Protection due to thermostat Thermostat becomes disconnected during normal combustion.
i i
invalid when
than find valve
valve
of
Up to three remote controls can be used with the water heater. No other manufacturer`s controls are suitable for use with this water heater.
death. light. It is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand. a , d not be pushed in or turned by hand, don`t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion. Wait five(5) minutes to clear out any gas. If you then smell gas , STOP! Follow "B" in the safety information above on this label. If you don`t smell gas, go to the next step.
u Chart
v operate v 118℉(48℃) and 122℉(50℃). Y range after ing operate the water heater.
Outdoor Gas Components(180,000BTU/hr--GA26ONG/LP) (150,000BTU/hr--GA22ONG/LP)
(199,000BTU/hr--GA30ONG/LP)