User Manual

7. Use the top and bottom tabs of the back cover heater to hang it from the wall. Do not use
the handle as a hanger. Make sure you install the heater carefully using a backup wrench in
the gas inlet hose to avoid stress and break it.
8.Attach the gas regulator by hand pressure to avoid breaking any parts and make sure the
gas tank valve is in the off position.
Before going to the HOW TO USE section:
Attention: make sure there are not ammable materials around, especially gasoline or
other fumes that can ignite. No objects can be placed on the top of the heater since they can
falI or burn. Both the top and the exhaust of the unit will be hot.
1. Turn on the incoming water supply ensuring that you have an adequate water pressure,
between 5-145 PSI.
2. Check that the shower nozzle is in the off position .
3. Open the gas valve on the cylinder all the way.
4. If a gas leak is detected, turn off the gas valve immediately.
5. Set the water regulator knob alI the way to the left.
6. Set the gas regulator knob on the front of the unit to the half way mark.
7. Turn the shower head knob to the "ON" position.
8. You will hear a series of clicks and the burner will ignite. If the burner does not ignite
after 5 seconds, turn off the heater and read the "Trouble shooting" section.
9. To ensure the draining of water after its use, open the drain valve (ribbed cylindrical
stem next to the water input valve).
IMPORTANT: Ensure that the drain valve is open and water is drained from the unit after
each use to avoid internal damage to the water regulator, especially if the outside
temperature is around or below 32°F or O°C.
The lack of proper drainage in your unit may cause damage to the heater that will not be
mended. See our warranty policy.
INSTALL ATION
07