User Manual
TECHNICAL SPECIFICATIONS
ADJUSTMENTS
The temperature of the incoming water together with the amount of heat applied are
inuential in the temperature of the outgoing water.
1. Set the gas regulator to low position and the water regulator to high position. This is the
lowest setting available.
2. To raise the outgoing temperature, turn the gas valve to the right. There will be a slight
delay between increasing the gas supply and the increase in water temperature. If you
want the highest setting available, then turn the gas regulator all the way to the maximum.
Adjust slowly and check the temperature frequently. The water might reach high
temperatures which can harm your skin. Make sure you test the water before using it.
*Temperature increases listed are based on use of the water heater under optimal conditions
with an incoming water temperature of 48°F. Variable factors such as incorrect or imperfect
installation or warmer incoming water temperature may yield different results.
GPM
0.5
1.0
1.4
LOWESTHIGHEST
Portable
116°F
73°F
60°F
145°F
89°F
70°F
Temp. Increase
per GPM
Product Code
Fuel Type
Recommended min.
Flow Activation
Maximum Flow Rate
BTU/h
Related Gas Pressure
Aplicable Water Pressure
Ignition
Protections
Pipe Fittings
Energy Efciency
Dimensions (WxHxL)
Weight
TECHNICAL SPECIFICATIONS PORTABLE
GA5PORT
LPG (Liquid Propane Gas)
5.58 GPM / 2.2 L / min
1.4 GPM
37,532 BTU/h
0.4 PSI
3.6 - 150 PSI
Electric Pulse, D Cell Battery Powered
(No electrical conection required)
Auto-cut off water control, automatic ignition,
anti-dry combustion protection, over-pressure,
overheating and ameout protection
½” NPT, incoming / outgoing water & gas
54 - 87%
11.61” x 15.74” x 5.11”
9.9 lbs
08