AS 101S - AS 121S - AS 151S AS 122S - AS 152S - AS 211S Owner’s Manual v 09.jun.
Congratulations on your purchase of a Markaudio product! Markaudio is a division of Parsek srl dedicated to pro audio sound reinforcement solutions. Building on the top-level reputation built up over many years by our industry-leading bass amplification brand Markbass, Markaudio boasts the same high level of innovation and engineering. The result is groundbreaking sound quality, impressive power, and shockingly light weight.
WELCOME TO THE WORLD OF MARKAUDIO 1. AS101S, AS121S, AS151S, AS122SF, AS152SF, AS211S - INTRODUCTION The AS 101S is an active subwoofer with a single 10” woofer and 500 watts of power. It’s the smallest subwoofer in the Markaudio product line, with a very compact design and exceptional bass frequency reproduction. The AS 121S is a single 12” active subwoofer.
2. IMPORTANT SAFETY INSTRUCTIONS 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) 15) 16) Read these instructions; Keep these instructions; Heed all warnings; Follow all instructions; Do not use this apparatus near water; Clean only with a dry cloth; Do not block any ventilation openings.
2. PRÉCAUTIONS D’EMPLOI 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) 15) 16) Lire ces instructions; Conserver ces instructions; Suivre tous les conseils d’utilisations; Suivre toutes les instructions; Ne pas utiliser cet appareil au bord de l’eau; Nettoyer uniquement avec un chiffon humide; Ne pas bloquer le système de ventilation.
3.1 CONTROL PANEL - AS 101S LEVEL CH1/CH2 (1) - High-pass output level control, which determines the amount of signal sent to the satellites. Turn the knob completely clockwise for unitary gain. PHASE (2) - Phase inversion 0°- 180°. In some installations, the subwoofer may be out of phase with the satellites. This switch allows you to reverse the phase of the subwoofer and align the system. CLIP (3) - Clip indicator LED. This indicator allows you to visually monitor the volume level of the loudspeaker.
signal from the electrical ground of the power amp module. This switch may be needed for the cancellation of hum due to ground loops with other apparatuses. If the audio signal is already disturbed when it arrives to the loudspeaker, this switch will not solve the problem. Identify the upstream component that is creating the problem, and take whatever measures are necessary to eliminate the hum.
LEVEL SUB (12) - This control determines the amount of signal that passes through the input stage of the subwoofer. Turning it completely clockwise will result in maximum gain. The appropriate subwoofer level can vary significantly depending on the acoustics of the venue and the genre of music you’re playing. Carefully set the satellites’ level first and then add bass frequencies (subwoofer level) as needed. CLIP (13) - Clip indicator LED.
installations,the subwoofer may be out of phase with the satellites. This switch allows you to reverse the phase of the subwoofer and align the system. LEVEL SUB (12) - This control determines the amount of signal that passes through the input stage of the subwoofer. Turning it completely clockwise will result in maximum gain. The appropriate subwoofer level can vary significantly depending on the acoustics of the venue and the genre of music you’re playing.
4. TECHINCAL DETAILS AS 101S AS 121S Acoustic Specs Sound Pressure Maximum peak SPL 129 dB 131 dB Frequency Response ±3dB 49 Hz - 120 Hz 47 Hz - 120 Hz Frequency Range ±10dB 47 Hz - 130 Hz 45 Hz - 130 Hz Dispersion Hor. x Vert. Loudspeakers Woofer LF 1 x 10” 1 x 12” Coil Neodymium Driver HF - Horn - Electrical Specs Amp Type RMS Power MOSFET Class A/B Class D 500W @ 4Ω 1200W @ 4Ω Slew Rate 15V / μs THD < 0.
AS 151S AS 122SF AS 152SF AS 211S 133 dB 136 dB 137 dB 139 dB 45 Hz - 120 Hz 41 Hz - 120 Hz 39 Hz - 120 Hz 35 Hz - 120 Hz 41 Hz - 130 Hz 39 Hz - 130 Hz 37 Hz - 130 Hz 30 Hz - 130 Hz 1 x 15” 2 x 12” 2 x 15” 1 x 21” Neodymium - Class D 1200W @ 4Ω 2000W @ 4Ω 15V / μs < 0.1% Forced air Thermal Limiter DC Current Short Circuit DSP Dynamic Filtering (OPTIONAL) 800 mV balanced 22 kΩ Switching 100V; 120V; 230V; 240V 50/60Hz (Voltage is factory preset according to region of sale).
Product specifications are subject to change without notice. Italy - Via Po, 52 - 66020 San Giovanni Teatino (Ch) Tel. +39 085 446 3755 - Fax +39 085 440 7764 www.markaudio.it - info@markaudio.