Owner`s manual

A-21
Nº502 Media Console Appendix
To Connect Without a Router:
To connect the Nº502 directly to the computer, you must use a network
crossover cable. A crossover cable is different from a standard network
cable and is designed specifically for connecting network access ports
directly together without the need for a hub, router, or switch.
Connect the crossover cable between the Ethernet port (RJ45 connector)
on the rear panel of the Nº502 and the Ethernet port of the computer.
Setting Up the
N
o
502
1. Power up the Nº502 Media Console.
2. Take the Nº502 out of Standby mode by pressing the Standby button
on the front panel.
3. Press the Setup button.
4. Select User Options from the Setup menu and press Enter.
5. Select Control Options and press Enter.
6. Select Network Setup and press Enter.
7. Assign the Network Setup parameters as follows:
•DHCP: Off
• Static IP address: 192.168.50.2
• Subnet address: 255.255.0.0
Note For more detailed information about this menu, refer to the “Network Setup”
description in the “Control Options” section found in Chapter 3: Customizing
the Nº502.
8. Press the Setup button to close the menu.
9. Power cycle the Nº502.
Note In order to see the Nº502, the computer must have the Internet Options
setup for a LAN (Local-Area Network) connection when using a router. If not
using a router, then ensure that the LAN network option is NOT selected on
the computer’s Internet Options setup.