Owner`s manual

2-5
Nº502 Media Console Basic Operation
3. Digital Audio
Inputs
Accept S/PDIF digital audio inputs using six coaxial RCA connectors,
labeled 1 to 6, and three TOSlink optical connectors, labeled 1 to 3.
4. AES/EBU Inputs
Accept two AES/EBU XLR inputs, labeled 1 and 2, for carrying digital
audio signals.
5. S-Video Inputs
Accept S-video inputs. There are three S-video input connectors labeled 1
to 3.
6. Component
Video Inputs
Accept component video inputs through four Y-Pb-Pr connector sets,
labeled 1 to 4.
7. HDMI Outputs
Provide HDMI outputs for HDMI-equipped displays through two
connectors labeled 1 and 2.
Note Only one video output connector, either the Component, HDMI-1, or
HDMI-2 connector, can be active at any given time.
8. Monitor Out
Provides an output for an alternative video monitor. The default setting
for the Monitor Out(put) is Off.
Note The front panel display and Monitor Out share the same video signal.
Therefore, when the Monitor Out connector is turned on, the front panel
display is deactivated.
The monitor output can only be turned on by a key press command on
the Nº502 front panel.
To activate the Monitor Out connector, press and hold the Display
Intensity button until the front panel display turns off. The Monitor Out
connector is now active.
To turn off the Monitor Out connector and reactivate the front panel
display, press and hold the Display Intensity button until the front panel
display turns on again.
9. Component
Video Output
Provides a component video output using BNC connectors.
Note If HDCP (High-Bandwidth Digital Content Protection) is active, then the
component video output is disabled. To verify this condition, open the
Detailed Status Panel for the Activity. The Detailed Status Panel identifies the
presence of HDCP source material. Refer to the “Status Panels” section at the
end of this chapter for further information.