Owner`s manual

2-14
Basic Operation Mark Levinson
• Lowering a crossover setting by two or more octaves.
• Changing the subwoofers from Mono to Stereo or from Stereo to
Mono, or making any other subwoofer configuration changes.
• Room Correction Adjust – defines the level of Room Correction
applied to the current Activity. The settings available are Low,
Medium Low, Medium, Medium High, and High. The lowest setting
only applies a minimal amount of Room Correction; the highest
setting applies the full correction. The Room Correction Adjust
parameter is not available for selection until the Automatic
Calibration has been successfully completed and the Room
Correction parameter is set to On.
Note Room Correction Adjust is disabled when Room Correction is set to Off.
• Recall – sets the Audio Adjust parameters to the factory default
settings. The Offset, Left/Right Balance, and Front/Back Fader param-
eters are set to zero, or Even. The Room Correction is set to Off and
the Room Correction Adjust is set to Medium.
Select OK to recall the factory default settings.
Select Cancel to exit without recalling the factory default settings.
Note The selected action is performed without pressing the Enter key.
The message “Audio Adjustment Settings Recalled” appears on the
front panel and main displays when the adjustment settings are
returned to the factory default settings.
Surround Mode Adjust Menu
The Surround Mode Adjust menu modifies the available Surround Mode
parameters. Adjustments made in this menu are systemwide, affecting all
applicable Activities.
For descriptions of the available suround mode parameter settings, refer
to the “Surround Modes Parameter Descriptions” section of Chapter 3:
Customizing the Nº502.