Owner`s manual

3-3
Nº502 Media Console Customizing the Nº502
Deleting an existing Setup, Profile, or Activity is permanent and cannot
be recovered. It can, however, be recreated by using the Add New
command and making the modifications again.
Note Setups and Profiles cannot be deleted if linked to an Activity. The Delete menu
option is grayed out and not accessible if the Setup or Profile cannot be
deleted.
Setup Step 1: Displays
The first decision you need to make is how many displays your home
theater system must support. For instance, you might want to use a front
projection system for watching movies but prefer to watch cable
television on a plasma display.
Create a new Display Setup for each display in your home theater
system. So, in the example above, you’d make two new Display Setups –
“Front Proj” and “Plasma”.
To create the new Display Setups:
1. Press Setup.
2. Select Displays and press Enter.
3. Select Add New and press Enter.
4. Select Name and press Enter.
5. Select the name of your new Display Setup using the Name Selector. If
required, refer to the “Name Selector” section at the end of this
chapter for instructions.
6. Select Save in the Name Selector and press Enter when finished
creating your new Display Setup name. The Nº502 saves the name and
opens the new Display Setup menu. Observe that the menu path on
the top of the screen indicates the new name.
7. Select Output Path and select the appropriate rear panel video output
connector for the Display Setup you just created.
8. If you are creating more than one new Display Setup, press the
button to return to Add New again.
9. Repeat Steps 3 through 7 until all you have created and named a new
Display Setup for each display you plan to use with your home theater
system.
For now, this is all you need to configure for each Display Setup. If
desired, refer to the next section, “Display Setup”, for explanations of the
other Display Setup options.