Owner`s manual

3-9
Nº502 Media Console Customizing the Nº502
The Speaker Setup menu contains the following options:
• Name – customizes the name of each Speaker Setup. Refer to the
“Add New, Name, & Delete” section found at the beginning of this
chapter for more details.
• Center – activates or deactivates the Center output.
• Surround – activates or deactivates the Surround outputs.
• Back – activates or deactivates the Surround Back outputs.
• Subwoofer 1– activates or deactivates the Subwoofer 1 outputs.
• Subwoofer 2 – activates or deactivates the Subwoofer 2 outputs.
• Subwoofer Image – identifies if the subwoofers are mono or stereo.
• Crossovers – sets the crossover frequency for each speaker.
• Auto Calibration – enters the automatic calibration process.
• Manual Calibration – provides access to manual calibration
controls.
• Delete Speaker Setup – deletes Speaker Setups that are no longer
needed. Refer to the “Add New, Name, & Delete” section found at the
beginning of this chapter for more details.
Activating
Surround Speakers
The Center, Surround, and Back menu options control the activation or
deactivation of each speaker for each Speaker Setup. To activate speakers
for the selected Speaker Setup, the Center, Surround, or Back menu option
must be set to Yes. When the menu option is active, then the associated
rear panel analog outputs (balanced and unbalanced) are also activated.
The speakers that can be activated are:
• Center – activates or deactivates the Center channel speaker.
• Surround – activates or deactivates the Surround, or Side, L/R (Left/
Right) speakers. The speakers can only be activated or deactivated as a
pair.
• Back – activates or deactivates the Surround Back, or Rear, L/R
speakers. The speakers can only be activated or deactivated as a pair.
Note The Front L/R speakers cannot be disabled. Therefore, there is no activation or
deactivation control for the Front L/R speakers.
If the menu option is set to No, then the speaker is deactivated for the
selected Speaker Setup and no signal is output to the associated rear panel
connectors.