Owner`s manual

3-43
Nº502 Media Console Customizing the Nº502
Internal Web Pages
The Nº502 supports network connection to a computer through the
Ethernet port. The Internal Web Pages act as the Nº502’s interface with
the network. These pages provide:
• Download/Upload Configuration - the Nº502 configuration and
calibration settings can be downloaded to a computer via the rear
panel Ethernet port. Previously saved configurations can also be
uploaded in the same manner. For more information, refer to the
“Saving the Nº502 Configuration” section of the Appendix.
• Software Upgrade - the interface for upgrading the Nº502
operating software. This interface will be used for any future software
upgrades. A separate document with further explanation will be
available with future software upgrades.
• Error Reporting - the Error Log page tracks ML Net or
system-related error messages. This page is a diagnostics tool for Mark
Levinson Customer Service use.
Note To access the Internal Web Pages requires proper network setup on both the
Nº502 and the computer. To set up the computer, refer to your computer
operating manual. To set up the Nº502, refer to the “Network Setup”
description in the “Control Options” section found earlier in this chapter.
ML Net
The ML Net protocol allows you to control two or more Mark Levinson
products simultaneously via the Ethernet port.
To use ML Net, the following conditions are required:
• only compatible with Mark Levinson products.
• all products must have Ethernet communication ports.
• an IP router with Auto-detect, capable of 10baseT or 100baseT
operation.
Refer to the product documentation of each Mark Levinson product to
verify compatibility.
Note Since ML Net operates through the use of a router and the Ethernet
connection, all devices must have networking capability. To set up the Nº502
for network operation, refer to the “Network Setup” description in the
“Control Options” section found earlier in this chapter.