Owner`s manual

3-45
Nº502 Media Console Customizing the Nº502
The figure below illustrates a typical ML Net setup:
If more devices are desired than the router can handle, connect the
additional devices first to a switch, then connect the uplink of the switch
to a normal port on the router.
Once connected, power on the devices one at a time to ensure proper
functioning of the ML Net controls. The Nº502 Media Console must be
powered on first. Allow each device to complete the initialization
sequence before proceeding to the next device.
Note If a Trigger control and ML Net are both active on the same device, the
Trigger control takes priority.
Discovering Slaves Before the Master device can control any Slave device, the Slave devices
must be “discovered” and assigned to the Master device.
The Nº502, as the Master device, searches for other devices via the
Ethernet connection, compiling a list of discovered devices and their
current status. Each discovered device must then be assigned to the ML
Net system.
To assign the Slave devices to the Nº502, go to the ML Net Setup menu,
located in the Setup: Control Options menu.
All of the devices found by the Nº502 are listed in the ML Net Setup
menu. The discovered devices are described by the following states:
• Unassigned – discovered device that is not assigned to the Nº502 or
any other Master device.
• Assigned – discovered device that is assigned (by the user) to the
Nº502.
-ControlOptions-MLNet
ML Net Setup
ML Net Status