- MARK LEVINSON INSTRUCTION MANUAL PREAMPLIFIER JC-2

INSTRUCTIONS FOR ASSEMBLING THE CA-1 CABLE ADAPTOR
1. The CA-1 may be mounted to a shelf, cabinet, or turntable base with one
wood screw. This keeps fragile tonearm leads from breaking or flexing.
2. Use LL-.6 or LL-3 cables to connect with your JC-2 or LNP-2 preamplifier.
3. Cut the phono connectors from the tonearm leads, nothing which wire is left
and which is right.
4. Strip the ends about 1/2" so that a center conductor and shield are prepared
for each end.
5. Insert the wires through the small holes on the edge of the CA-1 so they
project through the other side.
6. Solder the leads to the Lemo connectors, left and right. If the center
Conductor wire is 26 gauge or smaller, it will fit in the connector pin;
otherwise, wrap it around the pin and solder it.
7. Pulling the leads back through the CA-1 gently, install the front plate
with the button head screws and the 1/16" wrench.
8. Drop the teflon pillows into the strain relief holes.
9. Insert the strain relief screws and tighten gently
.
The system you just assembled is the closest thing to having one continuous
wire from tonearm to the first state of preamplifier electronics.