N 5105 0 N 5105 MC 0 TURNTABLE OWNER’S MANUAL
IMPORTANT: READ BEFORE PROCEEDING! • Read and follow the instructions • Keep all instructions for your reference. • Save all packing materials. The N0 5105 should only be moved or shipped in its original packaging to reduce the risk of damage in transit. IMPORTANT SAFETY INSTRUCTIONS PLEASE SEE ADDITIONAL SAFETY INSTRUCTIONS INCLUDED IN THE PACKAGE FOLLOW THE INSTRUCTIONS BELOW TO REDUCE RISK OF ELECTRICAL HAZARD OR INJURY. 1. To avoid electrical shock, do not open the motor housing. 2.
SETUP MOUNTING THE BELT PREPARATION Place the provided belt around the platter (1) and then around the pulley (2). Turn platter by hand to align belt on tread. Do not use sharp tools or pointed tweezers. This may damage belt, platter and pulley. To avoid transport damage your N 0 5105 comes in carefully designed packaging and is partially preassembled. Make sure you have plenty of clear flat space to unpack and set up the N 0 5105. We recommend at least 2ft x 2ft flat surface to set up.
INSTALLING AND ALIGNING A CARTRIDGE (If you purchased the N 0 5105 MC, a pre-mounted and calibrated cartridge is included; skip this section.) If you chose to mount an alternative cartridge, please use the included alignment template to adjust it to your turntable. Use the inner grid of the template to adjust your cartridge. Tonearm Template 10" Center Pin Fitted to Top Hole in Arm Carrier • Swing the tonearm over the alignment template so the stylus is as close as possible to the center of the grid.
CONNECTING THE NO5105 GENERAL USE Connect the N 0 5105 in 3 steps: • For best performance allow at least 20 hours of break-in time. 1. Connect the left and right RCA terminals to the phono inputs of a preamplifier using a high quality interconnect cable. • You can experiment with different platter mats, but be sure to recheck and adjust the VTA setting as needed. 2. Connect the ground terminal to the ground terminal on the phono input of the preamplifier. 3.
DIMENSIONS Top View Approx. 15.01" [381 mm] Approx. 15.55" [395 mm] 17.24" [438 mm] SPECIFICATIONS TURNTABLE NO5105 / TECHNICAL DATA 6 Dimensions: 17.2" x 15.6" x 6.1" / 438 mm x 395 mm x 154 mm Bearing: High precision bearing Weight: 75 lbs / 34 kg Chassis: 17.2" x 15" x 2" / 438 mm x 380 mm x 50 mm; aluminum; 3 height adjustable feet Drive system: Integrated DC-motor Platter: 11.75" diameter x 1.
Front View Approx. 6.08" [154 mm] Approx. 2.94" [75 mm] Approx. 0.98" [25 mm] Approx. 1.29" [33 mm] 11.75" [298.5 mm diameter] 12.01" [305 mm] Right View 10.41" [264.1 mm] Rear View 1.84" [47 mm] 3" [76.2 mm diameter] For more information please visit www.MarkLevinson.
HARMAN International Industries, Incorporated 8500 Balboa Boulevard Northridge, CA 91329 USA (818) 893-8411 (USA only) © 2020 HARMAN International Industries, Incorporated. All rights reserved. Mark Levinson is a trademark of HARMAN International Industries, Incorporated, registered in the United States and/or other countries. Part No. 070-00006 (rev. B.0) www.MarkLevinson.
