Owner's Manual

N
0
5105 / N
0
5105 MC TURNTABLE / OWNER’S MANUAL
5
CONNECTING THE N
O
5105
Connect the N
0
5105 in 3 steps:
1. Connect the left and right RCA terminals to the phono inputs of a preamplifier using a high
quality interconnect cable.
2. Connect the ground terminal to the ground terminal on the phono input of the preamplifier.
3. Select the appropriate included power cord for your region, and connect it to the
wall outlet.
AC Input
Tonearm Left
Channel
Tonearm Right
Channel Ground
OPERATION
OPERATING THE TURNTABLE
When connected to the AC mains, the N
0
5105 immediately enters Standby mode, which is
indicated by a slowly blinking light ring around the Standby/Stop button.
• To start the platter, press the button labeled with the desired speed. The light ring around
the speed button will illuminate, and the platter will slowly come up to the chosen speed.
The speed increases slowly to minimize wear on the belt.
• To stop the platter, press the Standby/Stop button once to stop. The light ring around the
Standby/Stop button will illuminate, and the platter will slowly come to a stop (because of
its high mass).
• To put the
N
0
5105 back into Standby mode, press and hold the Standby/Stop button for
three seconds. The light ring around the Standby/Stop button will start to blink slowly,
indicating that the unit is in Standby.
OPERATING THE TONEARM
• Open the arm tube clamp.
• Raise the tonearm by turning the lever on the tonearm lifter clockwise.
• Position the cartridge over the inlet groove of vinyl record.
• Lower the stylus onto the record by turning the lever on the tonearm lifter
counterclockwise.
• When the record has finished playing, lift the tonearm again and return it manually to the
park position.
GENERAL USE
• For best performance allow at least 20 hours of break-in time.
• You can experiment with different platter mats, but be sure to recheck and adjust the VTA
setting as needed.