User Manual

13
N
0
5302 POWER AMPLIFIER / OWNER’S MANUAL
Connect your Mark Levinson amplifier to a PC or tablet via
your home network as described above and open a browser.
Network speed and quality of the connection will affect the
response time of the BSP.
SETUP MENU
Click the Setup menu button on the left side of the BSP
screen to reveal a series of collapsible sub-menus.
FIRMWARE
Click Firmware to reveal the firmware version and date
loaded on your unit. To check if your unit’s firmware is up to
date, go to the N
0
5302 product page on www.MarkLevinson.
com, select the Downloads tab and look for the latest
firmware update file. If there is a later version, you may use
any of the options described below to update your unit. If
your unit’s firmware version is the same as the one displayed
on the website, no further action is required.
Browser method:
Make sure your unit is connected to a network with Internet
access. Click the SW Update button to open the Mark
Levinson FTP site. You will be prompted for confirmation.
Push OK and the unit will begin the update sequence. Please
be patient and DO NOT INTERRUPT the update process.
Updating can take up to 15 minutes. The unit will return to
Standby mode when complete.
Flash drive method:
1. Download the firmware file from the product page at
www.MarkLevinson.com and save it to a USB drive.
2. While the amplifier is out of the Standby mode (On) insert
the thumb drive in the USB port on the rear panel. The
N
0
5302 will read the USB drive.
3. The front panel LED will flash blue while the update is in
process.
4. When the firmware update is complete, the N
0
5302 will
enter standby mode.
The installation process takes at least 15 minutes and
should not be interrupted. The unit will cycle through
several stages of downloading and installing new operating
files and go in and out of Standby mode. BE PATIENT. The
unit will then enter Standby mode. Wait for the Standby
LED to start blinking before attempting to turn on the unit.
BE PATIENT.
SETUP
SETUP