User Manual
14
N
0
5302 POWER AMPLIFIER / OWNER’S MANUAL
Reload
Click to open a webpage that displays the N
0
5302’s
configuration information.
Save
Click to save the webpage setup configuration settings.
Restore
Click to restore the amplifier to the factory settings. The unit
will enter the “green”
Standby
mode when the restoration is
complete. The amplifier will lose network connection after
this step. Use the front panel
Standby
switch to exit standby
mode and restore your network connection as outlined on
page 12.
POWER
Browser (BSP) method
Click
Power
to expand the menu and reveal the available
power management choices.
Standby:
This setting lets you set the
Standby
mode to one of
the following options:
Green:
This mode removes power from almost all of the
N
0
5302’s circuits, allowing the unit to be activated only
via a wired IR control signal, a 5V – 12V trigger voltage
or a press of the
Standby
button. This mode provides
maximum power conservation and is the factory-default
Standby
mode.
Power Save:
This mode removes power from the N
0
5302’s
audio circuits but keeps the control circuitry powered and
ready to receive commands from any of the control inputs.
This mode provides moderate power conservation.
Normal:
This mode mutes the amplifier’s audio outputs
but keeps all of its control and audio circuits powered. This
mode provides the least amount of power conservation
but allows the audio circuits to remain warmed up to
deliver optimal performance at all times.
Auto Off:
This setting lets you engage or disengage the
Auto Off
function, which puts the N
0
5302 into the
Standby
mode after 20 minutes of inactivity (no audio signal, and
no user-control input).
Standby button method
Disconnect the amplifier’s power cable from the AC mains.
Reattach the power cable while pressing and holding the
front-panel
Standby
button. Continue to hold the
Standby
button until the Status LED flashes rapidly. The amplifier is
now in
Standby Select
mode. Each subsequent press of the
Standby
button selects the next
Standby
mode:
• Rapid red flash: Green mode
• Rapid blue flash: Power Save mode
• Rapid white flash: Normal mode
To exit
Standby Select
mode, wait approximately ten seconds
until the
Standby
LED stops rapidly flashing. The amplifier
will enter
Standby
and save your selection. The
Standby
LED
will flash red, slowly.
SETUP