User Manual

15
N
0
5302 POWER AMPLIFIER / OWNER’S MANUAL
NETWORK
Click Network to expand the menu. This menu offers access
to the following network-related parameters. They are useful
only if you want to connect your unit to a network to access
controls and setup functions via PC or tablet.
Name: Displays your N
0
5302’s network name in this format
N5302XXXX (the X’s represent the last four characters of the
unit’s unique MAC address). Use your mouse and keyboard
to change the network name.
Current Gateway: Displays the Gateway IP address. This
setting is informational only and does not provide any user
adjustments.
DHCP: Lets you toggle DHCP mode (network auto-
configuration) "On" or "Off". The factory default behavior is
"On". When the mode is set to "Off", you can specify static IP
and Subnet addresses for your N
0
5302.
Current IP: Shows the IP address currently assigned at the
factory (or by DHCP or manually) to your N
0
5302. Enter this
number in the address (URL) line of a browser connected to
the Internet. (This setting is informational only and does not
provide any user adjustments.)
Current Subnet: Shows the subnet address currently
assigned (by DHCP or manually) to your N
0
5302. (This
setting is informational only and does not provide any user
adjustments.)
TRIGGER
Trigger: This setting configures the 12V trigger. NOTE: Using
a trigger input overrides the Standby button.
Mode: These choices determine how the 12V trigger signals
are sent and received.
Normal: The default setting, appropriate for most other
components.
Pulsed: Some products (such as some older Mark Levinson
components) require a pulsed trigger signal.
Off: Disables the Trigger In/Out connections.
Delay: This setting determines the amount of time after
fully exiting the Standby mode that the unit waits to pass
a trigger signal to the trigger output jack. The choices are
0 - 10 seconds, with 0 being the default. NOTE: as it can
take a few seconds for the N
0
5302 to enter and exit Standby
mode, the net trigger delay time will be longer than the
value you select.
SETUP