Owner's Manual Preamplifier N 320S

Operation Considerations (continued)
• DO NOT use remote controls for different components at
the same time. Remote controls for different components can
interfere with one another.
Command Overview Unless otherwise specified, the numbered items in this section
indicate the commands the remote control performs during normal
operating mode. Refer to Section 3: Setup Menu and Section 4:
Controls & Modes for information about other commands the
remote control performs.
1. IR transmitter
Sends infrared signals to the front panel display IR receiver
when the Nº 320S is not using the rear panel ir input connector.
Refer to Operation Considerations (previous page) for additional
information.
2-16
Basic Operation Mark Levinson
standby
PREAMPLIFIER
Nº 320S
enter
setup
polarity
balance
display
mono
mute
volume
select
+
–
2
3
6
7
8
10
11
9
5
4
1
The numbers in the Nº 320S remote control illustration shown
above correspond to the numbered items in the Command
Overview section that begins on this page.
2. standby button
Places the Nº 320S into standby and
takes the Nº 320S out of standby,
which allows the Nº 320S to remain
warmed-up to deliver optimal
performance at all times. The front
panel standby LED blinks red to
indicate that the Nº 320S is in standby
and lights red to indicate that the
Nº 320S is not in standby.
Note
Power is still connected to the ~ac
mains connector when the Nº 320S
is in standby.
3. setup button
Opens and closes the setup menu,
which can be used to configure the
Nº 320S to suit individual preferences
and listening spaces. The front panel
setup LED lights red to indicate that
the setup menu is open.