Owner's manual

1-7
Nº32 Reference Preamplifier Getting Started
Note In some cases, the remote control IR transmitter LED will light more
dimly (or not at all) if the remote control batteries need to be replaced.
To replace the remote control batteries:
1. Locate the battery compartment cover on the bottom of the
remote control (the end opposite the IR transmitter).
2. Use the supplied 5/64-inch Allen key to remove the two screws
identified in Figure 1-1.
Figure 1-1: Remove the two screws to open the battery cover.
3. Remove the battery compartment cover.
4. Remove the old batteries in the battery compartment (if appli-
cable).
5. Insert two AAA alkaline batteries as shown in Figure 1-2. Make
sure the batteries are correctly inserted observing the proper
polarity.
Figure 1-2: Insert the batteries, observing polarity.
6. Align the battery compartment cover with the guide on the bot-
tom of the remote control.
7. Replace the two screws removed in step 2.
8. Properly dispose of the old batteries (if applicable).
Screws