Owner's Manual

04
4. FUNCTION OVERVIEW
GAIN (1) - Instrument input level control. The clip LED allows you to set the appropriate gain for your instrument’s signal level
and avoid degradation of your signal quality. To nd the optimal level, play at your top intensity and back o the gain control so
that the LED rarely turns on.
SPEED (2) - Controls the rate of sweep from 0.1 Hz to 3 Hz.
WIDTH (3) - Controls the width of the produced modulation.
MIX (4) - Controls the mix of dry signal and eected signal.
PRESETS (5) – This switch scrolls through the factory presets (from 1 to 6), changing the preset every time the switch is pressed.
Presets are modiable using the Markbass Pedal Controller software.
To access your Flanger presets, you must have the Chorus/Flanger switch (7) set to Flanger. To access the Chorus presets, you
must have the switch set to Chorus. The total number of presets can not exceed six.
True Bypass Switch (6)* - This switch turns the eect on and o (bypass mode). The “on” LED indicates that the eect is activated.
CONTROL (9) - The USB connection allows you to modify the parameters on your computer using the downloadable Markbass software (www.markbass.it in the product page), and then
store your favourite settings in the pedal to have them at your disposal whenever you need them!
Note: this switch also allows you to restore the pedal to its factory default setting, cancelling all modications made with the software. To restore the factory default settings, press this
button and hold it while you connect the pedal to its power source.
*True Bypass
When the pedal’s controls are ‘o’, your signal goes directly from the input jack to the output jack without any degradation of audio quality.
CHORUS/FLANGER Switch (7) - Switches between chorus and anger modes.
DISPLAY (8) -The status display is easy to read and always identies which eect is being applied.
5. CONNECTIONS
1/4” INPUT JACK 10 - Connect your instrument to the input jack. Make sure your amp is o and ensure that the volume is turned down before making connections.
DC IN 11  External power supply connection: 12VDC (550 mA minimum) PSU.
1/4” OUTPUT JACK LEFT/MONO 12  Sends the mono eect signal or, when both outputs are connected, the left channel of
the stereo output signal.
1/4” OUTPUT JACK RIGHT 13  Sends the right channel of the stereo output signal.