Owner's Manual
05
8. BLOCK DIAGRAM
6. MARKBASS PEDAL CONTROLLER SOFTWARE
To customize your Chorus Flanger pedal, simply download and install the software on your Mac or PC computer, and connect your pedal to the computer using a standard USB cable.
Launch the software, click on “CONNECT” button and wait for connection. The software gives you more control over the presets than the pedal itself does… so you can completely customize
your sounds in real time and save up to six presets to suit your needs perfectly. Future updates of the Markbass Pedal Controller software may be downloaded for free from this pedal’s product
page on the Markbass website (www.markbass.it) as they become available. Please stay tuned!
Although the Chorus Flanger pedal performs some pretty complex technical feats, Markbass has designed the user interface to be as simple and easy-to-use as possible!
SPEED: Controls the rate of the sweep (same as the pot on the pedal).
WIDTH: Controls the width of the eect’s modulation. In order to prevent excessive detuning, adjusting the width also aects the speed: as you increase the width, the speed slows.
CHORUS/FLANGER: Both chorus and anger presets can be modied and stored.
LOW CUT: This hi-pass lter, applied exclusively to the eected signal (cutting between 32 Hz and 576 Hz), helps you achieve a more focused sound by limiting the eect to your high end
only.
HIGH CUT: This low-pass lter allows you to lter out the range between 1 kHz and 16 kHz. Using this lter gives you a warmer, darker eected sound. The lter applies only to your eected
signal, leaving your dry signal full range.
WAVEFORM: Allows you to switch between Sine and Triangle waveform modulation.
AUDIO: This switch allows you to make your eects either mono or stereo.
CHORUS COLOUR: This parameter allows you to change the timbre of the eect, by altering the delay time and frequency.
FEEDBACK: (only available in anger mode) Controls the eect’s resonance.
FEEDBACK COLOUR: (only available in anger mode) Changes the resonance type from negative to positive.
GRAPHIC EQ: This 8-band graphic EQ allows you to ne-tune the overall equalization of your eected sound (it’s applied only to the eected signal).
7. TECHNICAL SPECS
INPUT: 1x ¼” mono jack
INPUT IMPEDANCE: 200 Kohm
OUTPUTS: 2x ¼” mono jack (mono L , stereo L+R)
PRESETS: 6 (user modiable)
GAIN: -10 ÷ +16dB
SPEED: 0.1 ÷ 3 Hz
WIDTH: 0 ÷ max
MIX: dry ÷ dry + wet
POWER REQUIREMENTS DC INPUT: +12 Vdc 550 mA minimum
DIMENSIONS: 170 x 145 x 60 mm
6.7” x 5.7” x 2.4”
WEIGHT: 730 g / 1.61 lbs