Owner`s manual

LIMITED WARRANTY Markbass oers an international limited warranty on Markbass products purchased from any authorized Markbass dealer, eective from the day of purchase. The terms of this warranty vary from country to country; please contact the Markbass distributor in your country for details. Please register this product online at www.markbass.it to establish the date of purchase. However, please note that you are required to retain a copy of your receipt as proof of purchase in order to receive warranty service. This warranty does not apply to any damage to the product caused by misuse, mishandling, accident, abuse, alteration, modication or unauthorized repairs. Product appearance and normal wear and tear (worn paint, scratches, etc.) are not covered by this warranty. Markbass reserves the right to be the sole arbiter regarding the misuse or abuse of this product. Markbass assumes no liability for any incidental or consequential damages, which may result from the failure of this product. Any warranties implied in fact or by law are limited to the duration of this express limited warranty. Your legal rights related to the warranty will vary depending on the country of purchase. WARRANTY CARD This product is guaranteed by the warranty provided in the country of purchase, under the following conditions: A - The Markbass warranty is only applicable if this document been properly completed (here or online) and if the original invoice/bill of sale, mentioning model, serial number and purchase date, is presented together with this document. B - The obligations of Markbass are limited to the repair of defects. Warranty repair eligibility will be decided at the sole discretion of Markbass or its representatives. Freight, freight insurance costs, and any other costs related to the repair of this product are not covered by this warranty. C - All warranty repairs must be made by Markbass or an authorized Markbass (PARSEK) service center. D - This warranty does not apply in the following instances: • if the damage was caused by accident, negligence or modications; use of non Markbass spare parts; or improper use, installation or packing; • if the serial number on the equipment is illegible; • if the damage was caused by lightning, water, re, incorrect main voltage, insufficient ventilation or any other cause beyond the control of Markbass. E - Markbass reserves the right to redesign or improve/modify its product at any time without any obligation to modify previously manufactured products.
Parsek srl. - Italy - 66020 San Giovanni Teatino (Ch) - Via Po, 52/A Tel. [phone] - Fax
[phone] - www.markbass.it - [e-mail]
TECHNICAL SPECS
INPUT IMPEDANCE: 1.5 Mohm / 6 Vpp
OUTPUT IMPEDANCE: 100 ohm / 6 Vpp
DRIVE: +50dB (maximum gain)
LEVEL OUTPUT: 0 to Max
GRAPHIC EQ: Freq. (Hz): 40, 80, 250, 400, 1200, 2000, 4000
Level: (-16dB, +16dB)
POWER REQUIREMENTS- DC INPUT: +9/+12VDC or standard 9-volt battery
DIMENSIONS: 98.8 x 38.3 x 124.2 mm / 3.89” x 1.51” x 4.89”
WEIGHT: 405 g / 0.89 lbs
BLOCK DIAGRAM
OWNER’S MANUAL
In
distortion
Drive Level
Out
equalizer
40 80
250
400
1.2K
2K 4K