v. 30.june.
IMPORTANT SAFETY INSTRUCTIONS 1) Read these instructions; 2) Keep these instructions; 3) Heed all warnings; 4) Follow all instructions; 5) Do not use this apparatus near water; 6) Clean only with dry cloth; 7) Do not block any ventilation openings.
2.CONTENTS INTRODUCTION 3 FUNCTIONS OVERVIEW (TOP PANEL) 4 FUNCTIONS OVERVIEW (REAR PANEL) 5 TECHNICAL SPECS 6 TROUBLESHOOTING 7 3. INTRODUCTION Congratulations on purchasing one of the world’s best bass amplifiers! Markbass amps are built to the highest standards by a small team of skilled technicians in San Giovanni Teatino, Italy.
. CMD SUPER COMBO K1 FRONT PANEL UNBALANCED 1/4” JACK INPUT 1/4” JACK INPUT GAIN CLIP LED LOW EQUALIZATION CONTROL KNOB MID LOW EQUALIZATION CONTROL KNOB MID HIGH EQUALIZATION CONTROL KNOB HIGH EQUALIZATION CONTROL KNOB VPF FILTER LEVEL CONTROL KNOB LINE OUT LEVEL KNOB MASTER VOLUME LEVEL KNOB POWER ON LED MAIN ON/OFF SWITCH MASTER INPUT 04 GAIN LOW MID LOW MID HIGH HIGH VPF LINE OUT CMD SUPER COMBO K1 1 2 3 4 5 6 7 8 9 10 11 12
1 2-3 4 5 6 7 8 9 AC POWER SOCKET SPEAKER OUTS SPEAKON (parallel wiring) TUNER OUT 1/4” JACK RETURN EFFECT 1/4” JACK SEND EFFECT 1/4” JACK INPUT GAIN PRE/POST EQUALIZATION CONTROL SWITCH GROUND LIFT CONTROL SWITCH LINE OUT XLR CMD SUPER COMBO K1 5. CMD SUPER COMBO K1 REAR PANEL MASTER LOW MID LOW MID HIGH + = SIGNAL SPEAKER 11OUT = GND HIGH VPF LINE OUT TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
. CMD SUPER COMBO K1 TECHNICAL DETAILS INPUT INPUT RETURN EFFECT CONTROLS GAIN LINE OUT PRE/POST EQ (for line out) GROUND LIFT MASTER VOLUME impedance: 500 Kohm, max. voltage: 15 Vpp impedance: 33 Kohm, max.
. TROUBLESHOOTING TIPS THERMAL PROTECTION SYMPTOM The amp gets hot and shuts down. PROBABLE CAUSE The amp has overheated, either as a result of inadequate ventilation or a damaged cooling system fan. When the amplifier cools down to a safe level, the amp will automatically restart. SUGGESTIONS Please verify that the fan is working properly, and that the cooling system ports are not obstructed. CURRENT PROTECTION SYMPTOM The amp turns on, but there is no signal coming from the speaker/s.
Product specifications are subject to change without notice Italy - 66020 San Giovanni Teatino (Ch) - Via Po, 52 - Tel. +39 085 446 3755 - Fax +39 085 440 7764 www.markbass.it - info@markbass.
