v. 24.july.
IMPORTANT SAFETY INSTRUCTIONS PRÉCAUTIONS D’EMPLOI 1) 2) 3) 4) 5) 6) 7) 8) 1) 2) 3) 4) 5) 6) 7) 8) Read these instructions; Keep these instructions; Heed all warnings; Follow all instructions; Do not use this apparatus near water; Clean only with dry cloth; Do not block any ventilation openings.
2. CONTENTS Introduction 3 Function Overview 4 Connections 4 Markbass Pedal Controller SOFTWARE 5 TECHNICAL SPECS 5 block diagram 5 3. INTRODUCTION Congratulations on your purchase of the Markbass stereo SUPER SYNTH. This pedal turns your bass into a synthesizer—with seriously cool sounds and no tracking delay! It also doubles as a digital octaver, with both octave up and octave down layers. The easy-to-read display always identifies what effect is being applied.
. FUNCTION OVERVIEW GAIN (1) - Controls the level of input into the pedal, from -10 ÷ +16dB. CUT FREQ / OCT -1 (2) - In Synth mode, this knob controls the cutoff frequency, from 70Hz to 14000Hz. In Octaver mode, it controls the volume level of the lower octave (one octave below your dry signal). TONE / OCT +1 (3) - In Synth mode, this knob allows you to select from seven (1-7) factory presets of Detune, Amp and Pan settings of the oscillators, and one user preset (8).
Limited Warranty Markbass offers an international limited warranty on Markbass products purchased from any authorized Markbass dealer, effective from the day of purchase. The terms of this warranty vary from country to country; please contact the Markbass distributor in your country for details. Please register this product online at www.markbass.it to establish the date of purchase.
WARRANTY CARD We’d like to thank you for choosing a Markbass product. If any problem occurs, please don’t hesitate to contact our support team at service@markbass.it. You can fill out this form and send a copy to Markbass (Parsek srl, Via Po 52, 66020 San Giovanni Teatino, CHIETI ITALY) or, even better, you can now register your warranty online in a matter of minutes, using our online registration form at www.markbass.it. Simply point, click and type in your information...
6. Markbass Pedal Controller SOFTWARE Mode: This switch toggles between Synth and Octaver modes (same as the switch on the pedal).
Product specifications are subject to change without notice Via Po, 52 - 66020 San Giovanni Teatino (Ch) - Italy - Tel. +39 085 446 3755 - Fax +39 085 440 7764 www.markbass.it - info@markbass.