Air Conditioner User Manual

ManualsBrandsMarley Engineered Products ManualsAir CompressorE3609-1325HFD

Specifications and Performance

INSTALLATION & OPERATING INSTRUCTIONS & PARTS MANUAL

MODELS: E3606-1325HFD, E3609-1325HFD

E3806-1325HFD, E3809-1325HFD

E4206-1325HFD, E4209-1325HFD

E4806-1325HFD, E4809-1325HFD

E6006-2325HFD, E6009-2325HFD

READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE, OR MAINTAIN THE PRODUCT DESCRIBED.

PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS

COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!

RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.

Air curtains produce a wall of continuously flowing air

that acts as a thermal barrier against outside air and

provides protection against insects, dust, odor, fumes

and other contaminant’s. Maintains interior conditioned

temperature by preventing heated or cooled air from

escaping through open doorways.

Heated air curtains are engineered to treat incoming

cold air at customers’ entrance areas. Used over front

door entrances, heated air curtains supplement existing

heat to prevent infiltration of colder outside air. Heated

units are not recommended for areas subject to high

winds.

Figure 2 Dimensions

Note that all dimensions are the same on all environmental

series units. Model number indicates width of unit.

(Example: E4800 indicates a 48” wide unit.)

MODEL

NUMBER

E3606-1325HFD

E3609-1325HFD

E4206-1325HFD

E4209-1325HFD

E4806-1325HFD

E4809-1325HFD

E6006-2325HFD

E6009-2325HFD

HEATER

VOLTAGE

208/3

MOTOR

VOLTAGE

208/3

HEATER

WATTS

6000

9000

6000

9000

6000

9000

6000

9000

HEATER

BTU/HR

HEATER

AMPS

20,478

30,717

20,478

30,717

20,478

30,717

20,478

30,717

16.7

25.0

16.7

25.0

16.7

25.0

16.7

25.0

CFM AT NOZZLE

(HI/LOW)

2025

2360

2700

3375

MOTOR

SIZE

1/4HP

Heated

Air Curtains

Note: For multiple unit installations, recommended spacing between units should be a minimum of 3-inches and a maximum of 6-inches.

Unit is allowed to extend beyond doorway width. Each unit must have individual power supply.

Description

REFER TO INDIVIDUAL MODEL NUMBERS

FOR UNIT WIDTH

”

Figure 1

Summary of content (8 pages)

PAGE 1
Heated Air Curtains INSTALLATION & OPERATING INSTRUCTIONS & PARTS MANUAL MODELS: E3606-1325HFD, E3609-1325HFD E3806-1325HFD, E3809-1325HFD E4206-1325HFD, E4209-1325HFD E4806-1325HFD, E4809-1325HFD E6006-2325HFD, E6009-2325HFD READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE, OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION.
PAGE 2
Unpacking 5. Carefully disconnect motor electric cord and heater plug assembly and remove two wing nuts on blower base. (See Figure 4.) 1. With packaged unit on the floor, carton arrows should point upward. 2. Carefully remove staples from top of carton and fold back sides. 3. Carefully remove cabinet from carton by lifting out unit using finger holes in styrofoam side inset and place on work surface.
PAGE 3
Installation 1. Using template provided, determine mounting location. 2. Drill holes and attach mounting hardware (not included). 3. Run proper size copper power supply conductors from the field power supply disconnects, (supplied by others) with insulation rated minimum 75°C (167.0°F). One set of conductors from 208VAC, 50/60Hz supply source shall be routed through the 3/4 inch conduit knockout, using a suitable knockout connected to the contactor contact terminals marked L1, L2, L3. 4.
PAGE 4
Operation NOTE: Air direction settings shown in Figures 6 & 7. 1. After power has been connected to unit, fans will start in either preset (high/low) speed selection. NOTE: Cold air will try to escape near floor level. Warm air will try to penetrate curtain near top of doorway. Air flow can be controlled by direction of nozzle louvers and by high/low settings. 2. Air velocity is controlled by selection of high or low speed indicator.
PAGE 5
Troubleshooting Chart SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION Fan inoperative 1. 2. 3. 4. 1. 2. 3. 4. Excessive noise 1. Wheel rubbing on housing. 2. Motor base or blower not securely anchored. 3. Defective motor bearings. 1. Center wheel. 2. Tighten mounting bolts. 3. Replace motor. Insufficient air flow 1. 2. 3. 4. 5. 1. 2. 3. 4. 5. Fans cut out on thermal overload (self-resets) 1. Low voltage. 2. Obstruction to blower wheel. 1. Verify correct wire size. 2. Remove obstruction.
PAGE 6
1. Replacement Parts For Air Curtain Cabinets 3 6 5 4 2 14 Replacement Parts For Motor Blower Assemblies (7) 12 11 16 13 15 8 10 9 9 2 6 3 4 8 5 Replacement Parts For Heater Units 7 1C 1D 1A 1B Figure 8 - Replacement Parts.
PAGE 7
Replacement Parts List For Air Curtain Cabinets Key No.
PAGE 8
LIMITED WARRANTY All products manufactured by Marley Engineered Products are warranted against defects in workmanship and materials for eighteen months from date of installation. This warranty does not apply to damage from accident, misuse, or alteration; nor where the connected voltage is more than 5% above the nameplate voltage; nor to equipment improperly installed or wired or maintained in violation of the product’s installation instructions.